Operating Manual and installation guide
                 Micro Cluster water Ionizer---  Industrial Model 
      
The syetem comes pre-installed, what you need is just
connect to your  water tap and connect power supply . it is a
plug and play device. But we still provide installation guide
below in case you need it!

the power voltage is 110v/220v two choices  AC 50/60HZ

If you do not want to use it for a while, please shut off the 
water inlet ball valve and turn off the power switch for the best safty.

Important Note:the power supply will automatically shut off when there is 
no water input or input water pressure is too low. 
So, when you connect power supply, the machine does not work 
until water comes in and has certain water pressure.

  
Before use and installation, please read the operating manual carefully.
It may take a few trial operations to get familiar with the machine,
But once you are familiar with the machine, It is easy to operate,
And no need for maintenance. The machine has a built in microchip
Which controls all of the circuits and operations. 

After the use, please shut off the water inlet ball valve and turn off the
power switch.


Warning:  Never drink acid water!

Four indicators and their meaning:

1. system cleansing, when this light on, at this time, system is 
self-cleansing,  you will hear some music sound. 
Water output still continue without any problem.
This function is unique than any other micorwater machines. 
With this function you do not need to change inside filters 
after every three years and with this function the system can take in
very poluted water and outputs very clean water!

2. Change inside filter, when this light on, you need to change filter. 
But the filter can use for about three years, because this super 
system has self cleansing function built.  Because  some times 
there might be is false light So,the best way is to ignore it 
and change filter every three years. Or if you wash filter
every month, the fileter may use for life time.

3. Wash inside filter:
First of all, take off the seals from the water inlet, 
water outlet, water discharge tube and from the bottom 
of the filters, and take off the plug from the 
frame of the filter.  Use a tube to connect the 
filter and water tap, and let water go through 
the filter.  Water should  not be stopped until 
no black particles come out from the filter. 
(Normally, wash lasts about 5-10 minutes.)
Wash should be done from the both holes on the bottom
of the filter.  The volume of water going in 
and coming out should be same, then put them back to 
the water unit and ready for use.

3. Volume too low,
This indicator is important, when volume is too low adjust the knob
On the primary filter attach to water tap to make volume right.
Otherwise , the output water can not guarantee At the desired pH value.

4. Volume too high
This indicator is important, when volume is too high adjust the knob
On the primary filter attach to water tap to make volume right.
Otherwise , the output water can not guarantee At the desired pH value.

Two water outlets.
1. Metal pipe is water discharge pipe. This is the outlet to collect 
drinking ( alkali water) water and acid water.
2. The outlet at the left of the bottom of machine, a
plastic pipe  is the waste water pipe, When You produce alkali water, this outlet discharge waste acid water
( still can be use for bath etc). When you produce acid water, 
this outlet discharge waste alkali water(but people can not drink it!)  

One water inlet.
The pipe connector at the middle of the bottom of machine is used to 
connect tap water by a primary filter attached to it. 
This is the only water inlet. The tap water is fed to the water unit
by this pipe.

The installation of the water unit.

1.  The place for installation:
   The water unit is to be installed above the water basin.                                                                                             close to the power socket, and should be kept away from direct sunlight and heat source.
2.  Installation Procedure:
(1) The water unit is to be installed on the wall (Generally, the top 
of the water unit is 1.6-1.7 meters high from the ground).  
Two holes are made first on the wall.  The distance between 
the two holes is 11cm. Plug nylon expansion screws into the holes, 
and use screws to secure the hook plates (attached to water unit).  
After that, hang on the water unit.

(2) Connect primary filter connector ( which fits most of the water tap
coonector to water tap, if connector of the filter is different with 
your tap connector, go to hardware shop to change your tap water connector,
it cost a few dollars. 

Attention: The preliminary filtering tube has a rough edge end, which
should be tightly clamped with the ball valve and the preliminary 
filtering  tube simultaneously with the attached clamp to prevent 
the filtering wick inside of the filtering tube to be pushed by
water to the other end of the preliminary filtering tube.  
The preliminary filtering tube will turn brown  after certain ]
time of use.  Replace it in time.

Use for the first time:

1. First of all, take off the seals from the water inlet, 
water outlet, water discharge tube and from the bottom 
of the filters, and take off the plug from the 
frame of the filter.  Use a tube to connect the 
filter and water tap, and let water go through 
the filter.  Water should  not be stopped until 
no black particles come out from the filter. 
(Normally, wash lasts about 5-10 minutes.)
Wash should be done from the both holes on the bottom
of the filter.  The volume of water going in 
and coming out should be same, then put them back to 
the water unit and ready for use.

Attention: No.1 filter is located on the right 
while No.2 purifying pot is located on the left.
2. Connect with the power source, turn on the power 
switch of the water unit.  Open the water inlet ball 
valve slowly, let water go through the water unit.  
Regulate water incoming flow at the rate of one 
liter/two minutes (e.g. 20 seconds needed for filling one glass.)
push "Activity Key" and regulate it to Grade I, and let water come 
out for three to five minutes, then it is ready for use.  
When the water unit operates, the water coming out from water
outlet can be collected for beautifying and diminishing inflammation.

Operation:

1. When the water unit is first put into operation, 
the drinking ionic water will be discharged from water discharge 
outlet, the acidic ionic water for beautifying and diminishing 
inflammation will run out from water outlet pipe.

2. The activity of the water unit has four grades.  
Generally speaking, drinking for the first time starts from Grade 
I or Grade II, use Grade II or Grade III in normal times, 
and use Grade III or IV for health protection.

3. If the user wants to have more beautifying acidic water,
push key "Beautify", then the light is on, the beautifying acidic water 
will come out from water discharge pipe.  At the end of use, 
push key "Drink", the water unit will return to normal drinking water
condition. Usually, usage for the beautifying acidic water 
or 5-10 minutes daily will prolong the life of the water unit.  
Activity Grade three is recommended when using the beautifying 
acidic water.
Attention: In case of restarting the water unit, it will return 
to drinking water state automatically, this state is the state
when units start .

D. Points for attention:
1. White flocculus appearing in the drinking ionic water are 
harmless and without any poison .  The appearing is caused by 
high hardness in the water. Ca and Mg ions separate out 
during the electrolysis process.  To eliminate that, there 
are two alternatives: one is to decrease the activity grade, 
the other is to install the pretreatment device.
2. When medicine is on, regulate the activity to Grade I.
3. The activity will not decrease if the ionic water is sealed in bottles 
and stored for one or two months in a dark place. 
4. The ionic water can be heated up for drinking.  Continuous 
boiling for more than five minutes will decrease the activity but 
will not affect drinking. 
5. The preliminary filtering tube will become brownish after some time.
Please loosen the clamp between the preliminary filtering tube and
the water unit, take out the tube, open the water tap and wash it 
with water.  The brown matter in the filtering wick can be washed away. 
If not, replace the preliminary filtering tube. ( machine comes with five of it)
6. If the pressure of the running water is too low, the ionic 
water flow will become very small, a pressure pump is to be provided. 

How To store the ionic water
Store it in a sealed bottle or container and put in refrigerator. 
It can store for one month  keeping the same pH value 

Major Technical Data 
Model:               Industrial
Voltage:            110V/220v  AC .   50/60 Hz
Power:               less than 100 W
Water Unit Body:     ( 13.8-12.6-6.7 inch )
                        Height-Width-Thickness
Ambient Temperature:      540   ( 41 F104 F )
Running Water Pressure:    0.1 Mpa -- 0.4 Mpa
Activity:              3 Grades for both acid water and Alkaila water
Weight of Water Unit:   28LB.
Protection Device:  Protection Device activates in case water  is run out.                                              
Installation mode:     Hanging  mode better.




Appendix

Brief introduction for weak alkali drinking  water 
and acidic ionic water.

70% of a human body weigh is water, and water content for an infant is
more than 80%.  A human body gets old resulting in lack of water.
More than half of the water content of a human body remains in the cells,
but not remain there unmoved.  That's why the water quality is a decisive
factor for a good health because 70% of a human body weight is water.
Every day a grown-up needs 2.5 liters of water, among which drinking 
water is about one liter, water from food is one liter added, metabolism in
the body generates 0.5 liter of water.  A grown-up excretes about 2.5 liters
of water every day, among which urea is 1.5 liters, defecating contains 0.1
liter of water, sweat is 0.5 liter, water in breathing out is 0.4 liter.  
Water fed in and water excreted out is basically in balance.  
A human body drinks more water in hot days in summer and after sports, 
while excreting becomes more simultaneously.

Seriousness of polluted water:
Water pollution becomes more serious (pesticide pollution, detergent
pollution, chloride pollution, germs pollution, heavy metal pollution
etc...) because of development in modern cities and indifferent attitude 
of the people towards pollution.

Is running water drinkable?
In order to realize sterilization, chlorine is added to running water, 
so that organic chloride and its derivation will from in the running water. 
Since 1981, the death of cancer has ranked first in Japan.  Especially, 
more people died of cancer in big cities, where high content of chloride in
running water.

Good conditions for drinking water
1. Containing harmless matters (Germs and chemical compounds not contained)
2. Containing certain mineral elements
3. Suitable hardness
4. Containing oxygen
5. Containing carbonic acid ions
6. Basic water
Japanese specialists from JVC point out that drinking water in small
 molecule aggregate is tasty.  Small molecule aggregate has high energy,
 moves fast, accelerates metabolism and excrete waste material.  Water unit
 is recommended in order to realize this.
Water unit can generate drinking ionic water and acidic beautifying
(diminishing  inflammation) ionic water while the traditional purifying
 device can hardly do this.
The effectiveness of the weak alkali  drinking ionic water
1. When you drink it, it especially quenches your thirst.
2. If you drink wine while taking drinking ionic water, it will help
you dispel the effect of alcohol.
3. If you make tea with the drinking ionic water, the tea will not 
taste pucker, the color of the tea water will be clear. 
If you make coffee with the drinking ionic water, the coffee will 
smell and taste good.
4. If you dilute whisky with the drinking ionic water, the taste 
will be excellent and you will not get drunk easily.
5. If the drinking ionic water is poured into milk powder, 
calcium will be added to infants.
6. If the drinking ionic water is taken to cook rice, the cooked rice
will be fragrant and tasty , and is not liable to turn putrid.
7. The soup will be tasty if the drinking ionic water is used.
8. To submerge seeds in the drinking ionic water, the germination percentage
can be increased.
9. If the drinking ionic water is used for dyeing, the color will be more 
attractive.
10. If Chinese ink is prepared with the drinking ionic water, the Chinese 
ink will be blacker and brighter.
11.To feed favorites with the drinking ionic water, the favorites will be
more energetic, the hair and feather will become bright.

The Japanese specialists proved that the 

The Benefits of weak alkali ionic water:
weak alkali ionic water has an effect on the following ailments: 
diabetes, bronchus asthma, hypersensitive dermatitis, hepatitis, chronic
rheumatic arthritis, high blood fat,  Meniere's syndrome, insomnia, obesity,
pains in loins, neuralgia, climacteric disease, Hong Kong foot, hemorrhoids, 
chronic dysentery, constipation, periodontosis.
The alkali ionic water not only can prevent ailment, but also can cure some
ailment . The ministry for public health in Japan has confirmed that the
weak alkali drinking ionic water has a curative effect on indigestion, hyper
chlorhydria, chromic diarrhea, stomach and intestine disease, constipation,
etc...

The effectiveness of the acidic  ionic water. 
1. It has an effect of astringent and makes the skin smooth and reduces 
wrinkles.
2. If hair is washed with this water, the hair will become more elastic 
and glossier.
3. This water can stop bleeding and sterilize the wound in case of scalds 
and cuts.
4. Hong Kong foot can be cured if it is submerged in the ionic water for 
diminishing inflammation.
5. To wash the hip of the infant with this water can prevent eczema.
6. To wash the gums and tears of the old people with this water can make 
their eyes feel cool and refreshing.
7. To wash tableware and towels with this water can realize sterilization 
and prevent bad smell.
8. To clean mats, floor and ceramic tiles with this water can remove dirt,
realize sterilization and prevent mildew.
9. To clean the glassware with this water will make the glassware look 
cleaner.
10.If the acidic ionic water is added while a bath is taken, there will 
be a beautifying effect on the skin.
11.To clean the hair and feather of the favorites with this water will make 
them glossy.
The acidic ionic water has an astringent effect on skin (cosmetic water).